View single post by smcmanus
 Posted: 03-16-2007 12:32 pm
PM Quote Reply Full Topic
smcmanus



Joined: 03-08-2006
Location:  
Posts: 123
Status: 
Offline
 Ouch! The parts book says shims are available from .060 to .130 of an inch.  This creates a situation for which I know not the answer.  The cams you have are probably regrinds which took off a lot of metal to get the desired profile.  Maybe someone has some over-sized shims or some uncut cams available.

My problem was the opposite.  I have the stock(?) cams and removed the gaskets when I fiddled with the valves.  I needed smaller shims but was fortunately they were available. 

Good Luck

Steve