 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2007 |
| Location: | |
| Posts: | 2 |
| Status: |
Offline
|
Dana
| View single post by Dana McPeek | |||||||||||||
| Posted: 03-13-2007 02:42 am |
|
||||||||||||
Dana McPeek
|
Using the drawing in LambandAndy's earlier message, I STRONGLY recommend that you cut a 3/4 x 3" slot in the forward face of the rail for access the the nut, in the unfortunate event that it should pop the welds. Nothing is as aggravating as having the nut spin forever, never to remove the seats again... Dana
|
||||||||||||
|
| |||||||||||||