Dan Eiland
|
Hi Mark, the gasket you show is the one I am referring to and I apologize if it sounded like I was referring to the relief valve having a gasket. I need to clean all the parts and then I can begin working with clean parts. I was just reading some of the past posts to the board about this subject. I think I am starting to understand how to measure some of these clearances but not all of them. I can understand using a straight edge and a feeler gauge to check the clearance from the rotors to the housing. I liked Judsons method of having a collection of gasket sizes on hand and dry fitting them until you have just the right amount of movement. I'm still not clear how to check the clearance between the inner and outer rotors, or the clearance between the outer rotor and the housing. I'm not clear as to how or what methods to use for these measurements.
|
