 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 08-07-2006 |
| Location: | Sydney, Australia |
| Posts: | 46 |
| Status: |
Offline
|
To get you a definitive answer on your problem I just pulled the starter motor out of one of my cars and the ring gear is about 1.32 in from the block face (the verniers were on a small angle but it should be within 0.02 , this is your 1.54 distance) the ring gear should sit up against the edge you point to in your original photo so yes yours has moved if there is a gap there. I have attached a photo of mine. Sorry looks like it is out with the gearbox.
Attachment: ring gear.jpg (Downloaded 379 times)
Last edited on 01-19-2007 10:14 am by normv