 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Cary, North Carolina USA |
| Posts: | 339 |
| Status: |
Offline
|
Ron
Last edited on 11-08-2006 12:26 pm by Ron Earp
| View single post by Ron Earp | |||||||||||||
| Posted: 11-08-2006 12:25 pm |
|
||||||||||||
Ron Earp
|
You can pin it on too, I know some folks do that as well. A few small diameter roll pins carefully put in through the ring gear into the flywheel will hold it well. Just have to make sure your pin sits below the level of the gear when you put them in. Ron Last edited on 11-08-2006 12:26 pm by Ron Earp |
||||||||||||
|
| |||||||||||||