 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-18-2005 |
| Location: | El Paso, Texas USA |
| Posts: | 159 |
| Status: |
Offline
|
Dan
| View single post by Dan Eiland | |||||||||||||
| Posted: 10-24-2006 01:49 am |
|
||||||||||||
Dan Eiland
|
So where in the top of the block does this go? I see two large openings-one at the front of the block and one at the rear of the block. I'm also with Kurt on this one, what else needs to be done? I'm having dowels added to all ten bolts around the main bearings, then having the block align bored. Without going overkill on a street machine, what else needs to be done? Dan
|
||||||||||||
|
| |||||||||||||