 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 08-20-2005 |
| Location: | Broomfield, Colorado USA |
| Posts: | 48 |
| Status: |
Offline
|
Just had my rotors turned last week. Before going in to get them done, Delta advised that the minimum thickness should be .343. I had my rotors turned, and had them set the new wheel bearing races into the hubs for the new wheel bearings I was installing. It was about $17 each for the rotor turn, and another $5 each to set the bearing races). I also installed rebuilt calipers, new pads, and the new bearings. In my case, all went VERY well, with good results.
I'm no expert, but your rotors look reasonable to me. If you can get them turned, do it. If not, the cost w/ Delta is not insane - I think about $115 each with exchange. Good luck!
Rick