 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Cary, North Carolina USA |
| Posts: | 339 |
| Status: |
Offline
|
Ron
| View single post by Ron Earp | |||||||||||||
| Posted: 04-29-2006 01:19 pm |
|
||||||||||||
Ron Earp
|
I'm replacing my oil cooler and hoses for the oil cooler, but I'd like to use the stock sandwich plate. Does anyone know the thread sizes on the sandwich plate, that is the plate itself and not the adapters for the hoses? I suppose I can carry it down to our local race shop and see if some AN or NPT/AN will fit it, but knowing the size ahead of time would be helpful. If anyone needs a good stock oil cooler mail me, it's for sale too, but the lines I'd throw out. Ron
|
||||||||||||
|
| |||||||||||||