View single post by Dan (Florida)
 Posted: 04-06-2005 03:39 pm
PM Quote Reply Full Topic
Dan (Florida)

 

Joined: 03-16-2005
Location: Ormond Beach, Florida USA
Posts: 97
Status: 
Offline
 Just to add my 2 cents, I would check to see if the slides are going up and down as the throttle is blipped. The slides in my stroms can be installed in any direction and I don't believe they will work too well if installed wrong. 

I just went around with an eroded needle in the rear carb and while it would run  it would idle very rich and partially foul at a stop sign.  I actually fixed it by filling in the eroded part with jb-weld epoxy and filing it back down. I can't comment on the condition of the jet that it serves, but it does run better.