View single post by Jim Ketcham
 Posted: 03-13-2005 06:56 pm
PM Quote Reply Full Topic
Jim Ketcham

 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 208
Status: 
Offline
 Hello Gary,

I had tried to respond to your post on the old board but it would not let me.

I have the same complaint about the front seal.  It is way to tight and impossible to install without the exterior rubber ripping.  I did get it with a liberal amount of Wellseal around the outside.

I do not see how you could install the rear seal from the inside out without destroying the sealing surface.  I fear you may have ruined your rear seal.  If you press it in from the other direction you should be able to easily get the required .1" setback.

Good luck,

Jim