View single post by Ron Earp
 Posted: 04-17-2006 12:29 am
PM Quote Reply Full Topic
Ron Earp



Joined: 03-12-2005
Location: Cary, North Carolina USA
Posts: 339
Status: 
Offline
 I'm coming down the home stretch on the race car and looking to rough align my JH.  The JH suspension geometry is not one I've dealt with before. It has two arms from the lower subframe to the lower suspension arm that looks like it is there to provide support.  It also looks as if it could provide toe in or out because it can push or pull the lower arm.

What is the correct way to set this thing up? Lower the car on the suspension and then make it tight?  How tight?  And, how - I have about 1.5" of clearance between the floor and my roll bar, thus there is no way to tighten this thing up in a normal garage, you'd need a lift with a cutout in the middle to pull this off.

Any suggestions would be great!

Thanks,

Ron