Jim DeClerck
|
OK, the new fuel/vapor line double clips are installed. As usual there was a bit of mystery involved and no instructions accompanied the clips. Each clip has 2 parts, a plastic insert that goes into the hole in the frame section and the plastic line clip which plugs into the plastic insert. When you buy the clips the 2 components are stuck/molded together as one unit. In order to use them you must first separate the 2 components. Cutting a groove with a knife where the 2 components are attached makes it easier to separate them. Then the insert can be pushed into the hole in the frame and the line clip can be inserted into the hole in the center of the insert. Finally, the lines can be snapped into the clip. Is anything straight forward with these machines?
|
