Jay
| Joined: | 08-05-2005 |
| Location: | Canton, Ohio USA |
| Posts: | 73 |
| Status: |
Offline
|
|
I'm in the process of sanding down my rear fender. I would like to remove the short vertical stainless trim that is attached to the rear edge of the right-rear fender. I've taken out the one small screw at the top but don't see any other fasteners. Looking through the opening inside the trunk (access to the side marker light), I do not see any nuts, like those on the trim that is attached to the trunk lid. Does anyone have any advise on how to remove this trim without distortion?
Do you think that it may have been reattached by some other means? I thought it might slide upward after I removed the screw, but it doesn't want to budge. Thanks!
|
