View single post by Jim DeClerck
 Posted: 03-09-2006 07:15 am
PM Quote Reply Full Topic
Jim DeClerck



Joined: 03-16-2005
Location: Huntington Beach, California USA
Posts: 73
Status: 
Offline
 My stainless steel threshold plates were also attached with a screw at each end and two long strips of adhesive material.  Tedious to remove without causing damage.  They show their age with a few small but unsightly dents, scratches, marrs, etc., accumulated over the years.  

I found a guy who made me an identical new set, but without the holes, out of thicker stainless - less susceptible to dents, etc.  I am planning to cement them in place with silicone seal and no screws.  If they shift in use, I'll drill the two holes and secure them with #4 SS pan head philips head screws, but if they don't move they'll look nicer without screw heads showing.