View single post by Jim DeClerck
 Posted: 02-22-2006 07:48 am
PM Quote Reply Full Topic
Jim DeClerck



Joined: 03-16-2005
Location: Huntington Beach, California USA
Posts: 73
Status: 
Offline
   Turns out the broken rocker switch I had was the Hazard switch.  I tried drilling it out to insert a pivot shaft but the bit caught a spring inside the rocker.  End of experiment, end of rocker switch. 

  For the Panel lights I connected 2 spade terminals to the ends of a short length of wire and pluged the spades into the female terminals on the wires that had been connected to the rheostat Panel light controller.  Works fine and no chance of dimming the not-that-bright panel lights ever again.