View single post by Brett Gibson JH5 20497
 Posted: 01-11-2006 03:56 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497

 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 Bill, the new bushing should have two little numbs on it that fit into holes close to the end of the column tube that the steering shaft runs thru, engine bay side, you just need to clean the old one out and push the new one in with those numbs lined up.

Personally I was not impressed with the new plastic rubbery one, so when I got mine I just duplicated it out of brass and installed that instead, hopefully it will now last the life of the car, something Jensen should have done in the first place.

Brett.