View single post by Joel
 Posted: 12-24-2005 12:37 am
PM Quote Reply Full Topic
Joel

 

Joined: 07-01-2005
Location: San Diego, USA
Posts: 184
Status: 
Offline
 Ok, I'm back after a hiatus. No work done yet. 1st thing I want to do is get rid of the ballast resistor wire. It's in bad shape (cracked w/ wire exposed) at the coil so I figure that's the 1st place to start.

I have a wiring diagram. My diagram shows the wire going into some kind of a junction (w/ one off the starter, heat temp indicator and one more i can't remember off the top of my head). Where is that junction and what does it look like?

I assume it's under the hood but couldn't find it. I can't imagine why you would need this connection under the dash - but is it?

Would it be the brown,shiny coated wire under the dash? I'm just planning to run a straight wire - once I figure out which one it is.

Merry Christmas all!!

Cheers,

Last edited on 12-24-2005 02:04 am by Joel