 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 01-14-2025 |
| Location: | |
| Posts: | 12 |
| Status: |
Offline
|
Attached is a photo of the head gasket that I recently dismantled. Engine overheating caused the head gasket to fail. I’ve not seen a blown head gasket before on an engine with liners, so I’m not sure what to expect, but this doesn’t look good!
Next job is to clean the head up and check for true. Any other insight/advice very welcome. I’ve done a good few head gaskets, but not for this engine. I have been digesting Mr Engel’s advice pieces so I’m not coming to it cold.
This is a LotusBits built 912 stroked to 2.2 with about 3 hours on it.
Attachment: head gasket.jpg (Downloaded 38 times)
Last edited on 01-16-2025 09:19 pm by stewart.wigg@gmail.com