View single post by redracer
 Posted: 08-17-2024 12:58 am
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Online
 I just wrote a reply to Corey last week about headers: I probably have about 7 sets I welded and brazed a few months ago. Let me know if anyone wants a set; here's a copy of the reply i had written:

Just got through a couple of months ago welding and brazing all the old headers I had taken off the cars I had(I had 26+) since they don't make the 2 piece ones anymore. The picture you sent of your header appears to be an original---the severe bend in #4 was always a "weak" point and usually had to be brazed after it cracked there. When I autocrossed, I had to do that a few times , as we were not allowed to put aftermarket ones on. Also, the "Y" pipes I have are aftermarket and of a better "flow" design than the original.
good luck, bruce