View single post by JH12947
 Posted: 08-11-2024 07:42 pm
PM Quote Reply Full Topic
JH12947

 

Joined: 07-14-2022
Location: Penticton, British Columbia Canada
Posts: 52
Status: 
Offline
 I've attached a screenshot from one of my YouTube videos that shows the header. As you can see, the individual runners from 1 & 4 gather at a Y pipe, as do the runners for 2 & 3 - all fully welded. The outputs from these 2 Y pipes then travel down to another Y pipe that is again fully welded. The single outlet from there runs into the front muffler.

There is no removing of any Y pipes or separating the header into parts.

Looking at the photos of the unit on the Martin Robey site it looks like the upper sections are supposed to be welded as they are. The lower Y is not, but this section is below the car so shouldn't be an issue unless the header is supposed to be removed from above.

Attachment: Header.jpg (Downloaded 52 times)

Last edited on 08-11-2024 07:59 pm by JH12947