View single post by Mark Rosenbaum
 Posted: 12-01-2005 06:24 am
PM Quote Reply Full Topic
Mark Rosenbaum



Joined: 03-12-2005
Location: Kingman, Arizona USA
Posts: 532
Status: 
Offline
 What I used on my car was a ribbed stair tread runner, made from a rubber-like material that was found by test to resist gasoline and other common solvents. I cut this into strips which were then attached using contact cement to the fuel tank on the underside and in the areas where the retaining straps would make contact.  The ribs are sufficiently stiff that an air space is present even when the tank is full.  Cost was very low, IIRC about US $1.