 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 08-02-2018 |
| Location: | Long Beach, California USA |
| Posts: | 452 |
| Status: |
Offline
|
The question of drainage holes in the floorpans is one that has come up on any number of message boards. The general consensus is that they are alignment holes. There are alignment pegs on the jig that the car sits on during assembly. The stamped floorboards with the holes are simply placed on the pegs then it can be welded into place and down the line some gomer pops the plugs into the holes.
If you think about it drain holes in a car don't make much sense and if that was their purpose why would they plug them.