View single post by vnavaret
 Posted: 06-19-2023 01:31 am
PM Quote Reply Full Topic
vnavaret



Joined: 04-07-2022
Location: Oregon USA
Posts: 54
Status: 
Offline
 Lastly, here is the front left inner fender showing the state of the repairs made by my PO. Note that the front of the frame is free floating by virtue of its completely failed welds. Also note the ragged attachment of the inner fender, and many (not shown) perforations from rust. The frame will be cleaned up, reattached, and receive welded reinforcements. The tip of the frame is also badly misaligned, so I will be using a hydraulic jack before reattachment to push it back into alignment. The inner fender bodges will be cut away and replaced with new metal.

I had never welded before, but I have been forced to learn on this car. It is a real challenge!

I am using a $250 flux MIG welder which is messy, but is getting the job done. After cleanup the work actually looks decent. Stay tuned for more updates in the near future.

After this, I will be tackling the rust in the quarter panels, and by then I expect to be pretty dang good at welding with my cheapo welder.

Vance

Attachment: IMG_0342[1].jpg (Downloaded 202 times)

Last edited on 06-19-2023 02:10 am by vnavaret