Art DeKneef
| Joined: | 03-12-2005 |
| Location: | Mesa, Arizona USA |
| Posts: | 338 |
| Status: |
Offline
|
|
Hopefully you took lots of measurements before removing the floor pan. When I did that to one of my cars I took lots of measurements, made some braces for the door openings and for side to side and made everything to be as level as possible in the garage. Also, I made new floor pans before I cut anything. There are a lot of spot welds to go through. Like any kind of surgery like this, it's go slow and keep checking as you proceed.
As for the 5-speed replacement you might have to check the rear joint to make sure it mates with your current rear axle. I have heard some of them had a smaller joint connection that needed to be fixed. I was lucky that mine replaced with little extra drama.
|
