View single post by redracer
 Posted: 01-29-2023 07:38 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 Notice the 2nd pic where the positive lead for the sending unit is. A double layer of old bicycle tubing as well as a 3/8" hose eas needed to protect it from grounding out from the hold down strap.
The 3rd pic shows only 2 breather tubes for the tank, so the breather for the axle is now left off. There is no pressure relief valve as on the original tank.
Finally, here's a correct sending unit box/number since the one they sent was backwards (and only 180 ohms).
My advice would be to get the one from Martin Robey, as it shows the correct fittings.

Attachment: Aluminum Gas Tank, ebay.jpg1.jpg (Downloaded 78 times)