View single post by Ed Weber
 Posted: 08-05-2022 08:28 pm
PM Quote Reply Full Topic
Ed Weber

 

Joined: 05-06-2022
Location: Woodland Hills, California USA
Posts: 5
Status: 
Offline
 Just wanted to say this was helpful getting my own pedalbox redone.  The three shafts have a bit of knurling on one end that is pressed into the aluminum casting.  The other end is just a tight fit. A little bit of pounding with a hammer and punch got them out without trouble.
I've got a pic of the pedalbox with the pressed in end marked in red - it of course isn't the same for all three.

Attachment: pedalbox.jpg (Downloaded 66 times)