View single post by Spaceman
 Posted: 02-28-2022 11:28 pm
PM Quote Reply Full Topic
Spaceman



Joined: 05-30-2017
Location:  
Posts: 25
Status: 
Offline
 Got my Sunbeam Rapier OD home, and from watching the rebuild video on the Sunbeam page, it doesn't look too daunting. I am thinking the only difference is the collar around the input shaft for the clutch throw out bearing to sit on. So can they just be swapped over? Are any parts required? The spline is the same, but don't know about the end, if it will fit the 907 crank end.