 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-15-2013 |
| Location: | |
| Posts: | 203 |
| Status: |
Offline
|
Attachment: Gustafsen starter low res.jpg (Downloaded 88 times)
Last edited on 01-03-2022 11:10 pm by Tom Bradley
| View single post by Tom Bradley | |||||||||||||
| Posted: 01-03-2022 11:07 pm |
|
||||||||||||
Tom Bradley
|
I also got a Gustafsen starter from Dave Bean. Been happy with it so far. It IS possible to install it rotated enough for my cables to fit (see pic). It did take more effort to install: you need the right tools and it had to go in stages as I recall. I did this mainly to get the high-current cable farther away from the engine block. I was afraid of some small piece of metal falling down there and shorting it out. If you go with the standard installation angle, be sure to have a rubber hood that completely covers the entire connection. Attachment: Gustafsen starter low res.jpg (Downloaded 88 times) Last edited on 01-03-2022 11:10 pm by Tom Bradley |
||||||||||||
|
| |||||||||||||