 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-10-2012 |
| Location: | BROOKHAVEN, Georgia USA |
| Posts: | 652 |
| Status: |
Offline
|
First, we assume you have cleaned the shoes and put a VERY light smearing of brake grease on the 2 pins, the washers, and the parts that slide on the metal. The first picture shows the tools necessary; the special brake shoe pliers are not necessary(unless you like using them), but are used to REMOVE the shoes). Basically, the needle nosed plier and a #0 round screw driver are all that I need.[img][/img]
Attachment: J-H Lockheed brake shoes installation.jpg (Downloaded 73 times)