| View single post by redracer | |||||||||||||
| Posted: 08-03-2021 01:23 am |
|
||||||||||||
redracer
|
The voltage stabilizer controls ONLY the temp and fuel gauges. It is located between these 2 gauges on the back panel, and the ground for it is a #2 cross-point screw into the metal panel--this minimal connection gets corroded and non-electrical after many years. MOSS sells a solid state one that will be more accurate than the bi-metal one inside the original. As for the other 2 gauges, you are either NOT grounded or the +/positive voltage is not getting there. Use a VOM to find the fault. good luck, bruce
|
||||||||||||
|
| |||||||||||||
