 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 05-30-2017 |
| Location: | |
| Posts: | 25 |
| Status: |
Offline
|
| View single post by Spaceman | |||||||||||||
| Posted: 11-24-2020 09:20 pm |
|
||||||||||||
Spaceman
|
I thought the seam was stiched over, but was able to get a coathanger to push thru, so my technique will be, lube the bar with soap and water like you put on bike handles, and heat up the vinyl top where it has to bend, it will be tight but i think I can get away without opening up anything. I might be easier to cut a slot and slip it through.
|
||||||||||||
|
| |||||||||||||