 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-16-2016 |
| Location: | |
| Posts: | 71 |
| Status: |
Offline
|
your thoughts?
| View single post by jomac | |||||||||||||
| Posted: 11-09-2020 04:38 pm |
|
||||||||||||
jomac
|
today i did inspection on my 2 piece driveshaft. the shaft assembly is like new condition. the bearing is fine and the rubber boot the surrounds it is in very good condition. the noise i heard earlier is not present. but i did notice that the 2 piece design i can slide the second half of the shaft back and forth about 1/2". which isn't a problem, but i notice when i slide it rearward i hits a pinion shaft component as a stop.The noise i get while driving occurs whenever i apply throttle, else the car coast along quietly. looking at the rear diff input area there is a seal, but the seal is recessed inside the diff housing,which allows movement. i can't find any info on how this seal should look. my assumption is that when i apply throttle while cruising the driveshaft is pushed against the metal surface causing a noise. else its bearing in the 5 speed. your thoughts?
|
||||||||||||
|
| |||||||||||||