View single post by redracer
 Posted: 10-19-2020 03:22 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 didn't realize you had taken the oil pump housing off the auxiliary housing(the split pin is in the back side of your pic).
Unfortunately, there is a special plastic thickness gasket that goes between the auxiliary housing and the pump housing in 5 different thicknesses.(0.005"-0.0015") .
Most of the time the 0.005" gasket has been used, and a few times I have needed the 0.004" size, but you will need to measure the for-aft movement now. I use 0.0005-0.001" for the gap; any more gap leads to too much air