 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 05-30-2017 |
| Location: | |
| Posts: | 25 |
| Status: |
Offline
|
| View single post by Spaceman | |||||||||||||
| Posted: 04-27-2020 09:22 pm |
|
||||||||||||
Spaceman
|
I have just replaced one of mine, but i think I tapped it in too far, there is an oil drain hole or two behind the seal, and I was told, if it is blocked, you will get too much pressure behind the seal, and it will puke out oil. This almost sounds like to problem you were having. So when you put in seals, do you seat them all the way? Or just flush with the cam housing?
|
||||||||||||
|
| |||||||||||||