View single post by discogodfather
 Posted: 04-15-2020 05:33 am
PM Quote Reply Full Topic
discogodfather



Joined: 09-17-2007
Location: San Francisco, California USA
Posts: 221
Status: 
Offline
 I thought this might be a good thread to ask- been thinking about adding an accusump (oil accumulator). Most of the literature on these says to put it on the return line from oil cooler (with a check valve highly recommended). Seems like this would be pushing oil into the filter, then into the engine.

Is this the best location? I also see how the oil pressure sender "plate" might be a good location, although it's a small opening. That hits the mains directly through the main oil galley correct?