Ralph H
|
I have located the oil fill canister from my parts car and think I can adapt it to act as an open ended breather. REDRACER - I thought I could mount the canister on its side on the right side inner fender (where the orange box is on John's photo above) with one tube from the block to the bottom connection and a breather filter similar to Discogodfather photo shown here pointing straight up. That would put a new K&N filter at the same level as the air filters. The third opening will get plugged and I already made a new rubber gasket to fully seal the previous twist off filler top. It is pretty high up and if there is any oil it should drain back into the block on acceleration or hills. I.E. self cleaning. Thoughts?
|
