View single post by redracer
 Posted: 02-29-2020 02:59 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 Most likely a ground connection; many times on other's cars(as well as my own) I have had to remove the pin connectors and clean each one and reinsert. The taillights(all 3--the running.stop, the backup, and the turn)should have had the ground inside the bulb housing soldered to the copper tab.
I strongly recommend doing this: This is fairly easy to do;a coarse fiberglass bristle brush (I have posted this before so look it up if you wish) to clean the interface between the copper ground tab and the round outer face will give a nice soldering joint.
best wishes, bruce