 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-17-2007 |
| Location: | San Francisco, California USA |
| Posts: | 221 |
| Status: |
Offline
|
If you mix-n-match tensioner and seal housing parts, then tensioner roller alignment can be off.
I'll see if this setup works, it sits very nicely and seems to line up but I am going to be scrutinizing it in use. Truth be told my stock tensioner was always a problem, I think the pulley was sliding around on the bearings quite a bit. It had some minor alignment issues from time to time. I was always fiddling with it if I remember correctly. Going to be running the blue belt, hopefully that helps.
Is there a way to tell what year the engine is from it's serial number? I am not sure if this is the original engine in my 73.
Last edited on 02-09-2020 02:51 pm by discogodfather