 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 06-24-2006 |
| Location: | Charlotte, North Carolina USA |
| Posts: | 106 |
| Status: |
Offline
|
Attachment: 69D5BADD-7AF2-4FD1-83BC-0D6EFD055E31.jpeg (Downloaded 73 times)
| View single post by flatlanderep | |||||||||||||
| Posted: 11-22-2019 03:38 am |
|
||||||||||||
flatlanderep
|
I started rotating the dist. towards me or rotating towards the oil filter while keeping inward pressure on dist cap. Found this was stalling out although I had increased the idle speed to start this process as you suggested. So I changed direction rotating towards the engine. Seems like I got the best response and I tightened dist. pinch clamp. I checked timing with timing light & it was about 18 degrees with RPM just under 1000. I have attached a photo of where the dist. is located, about 11 o’clock compared to 9:30 with mechanical points. Does this matter? Should I attempt to rotate dist to get closer to 12 degrees? Attachment: 69D5BADD-7AF2-4FD1-83BC-0D6EFD055E31.jpeg (Downloaded 73 times)
|
||||||||||||
|
| |||||||||||||