 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 06-24-2006 |
| Location: | Charlotte, North Carolina USA |
| Posts: | 106 |
| Status: |
Offline
|
Attachment: 24B95A23-8DC2-4682-A466-8A40014C3687.jpeg (Downloaded 114 times)
| View single post by flatlanderep | |||||||||||||
| Posted: 11-06-2019 05:07 am |
|
||||||||||||
flatlanderep
|
After spending a few couple of hours following Tim E. suggestions, I decided to start from the beginning. Took out distributor and sending pics of the Pertronix install and the dis. shaft. First, is the magnetic ring down far enough on the shaft? Is does not go down any further and aligns with the amplifier. Also, I don’t see how the clockwise or ccwise position can be changed because the mounting plate fits exactly where the 2 holes are located and it does not slide. Also noticed that it appears that a washer is missing at the end of the distributor shaft. See attached pics. Attachment: 24B95A23-8DC2-4682-A466-8A40014C3687.jpeg (Downloaded 114 times)
|
||||||||||||
|
| |||||||||||||