 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-22-2005 |
| Location: | Huntington Beach , California USA |
| Posts: | 96 |
| Status: |
Offline
|
https://www.wikihow.com/Adjust-Timing
Last edited on 11-05-2019 01:14 am by Tim Murphy
| View single post by Tim Murphy | |||||||||||||
| Posted: 11-05-2019 12:59 am |
|
||||||||||||
Tim Murphy
|
From your pictures it looks like the crank, cams and distributor are set up correctly. Which is to be expected as it ran good before the pertronix install. Now you need to know when the sparkplug is firing. A timing light will flash when the spark plug fires. I am going to link to a couple of "how tos" sites that may be helpful. Using a basic inductive timing light is not difficult. I find it much easier to see the results if it is dark, or at least not bright, when I actually view the timing light flashes on the crank pully. So, for example, if you are working in the garage, get things set up and then turn off most of the lights. For right now you are just concerned with idle timing. https://www.wikihow.com/Adjust-Timing Last edited on 11-05-2019 01:14 am by Tim Murphy |
||||||||||||
|
| |||||||||||||