 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 06-24-2006 |
| Location: | Charlotte, North Carolina USA |
| Posts: | 106 |
| Status: |
Offline
|
Steve
| View single post by flatlanderep | |||||||||||||
| Posted: 11-02-2019 02:01 am |
|
||||||||||||
flatlanderep
|
Installed Pertronix Ignitor I today and expected car to start but it keeps cranking. I installed new NGK BPR6ES plugs and gapped the plugs at 0.035. I am getting spark at all 4 plugs, verified by removing plug, placing on engine and turning the key. Lined up crank pulleys, removed dizzy cap and rotor pointing to #1 plug wire. I called Pertronix tech support and told the support staff person that I have a Bosch “blue” coil and he stated that will work. I told him the wires that are connected to the coil and he said that they were correct. Also there is no ballast resistor and probably removed by PO. Any suggestions to solve why car will not start? Car started prior to the Pertronix. Steve
|
||||||||||||
|
| |||||||||||||