 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 08-02-2018 |
| Location: | Long Beach, California USA |
| Posts: | 452 |
| Status: |
Offline
|
You're right, there has already been a thread or two on this issue. In my case there was AGC 30A fuse in the #3 fuse holder so when the cigar lighter shorted the wires melted down before the fuse finally blew. Ironically when it shorted the wires ended up protecting the fuse rather than the other way around. When I get it back together I think I'll use 15a fuses, they're a bit smaller than original but I'd rather have to replace fuses than a wiring harness.