View single post by redracer
 Posted: 08-19-2019 05:45 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 652
Status: 
Offline
 The column will "drop down" a bit after you remove the obvious bolts & screws holding it in place(advise photoing it beforehand for easier reinstalling).
You will need to drill a small hole in the center for each of the two break-off bolts holding the aluminum column lock in place for(a small ease-out should be fine as there is not much force holding the bolts in); 5/16 allen bolts fit perfectly in when reinstalling.
As Frank said, the 4 digit # should be magic-marked on the bottom half of the two pieces and can be easily "erased" by any cleaner, so be careful there.
bruce