View single post by noomg
 Posted: 06-05-2019 06:11 pm
PM Quote Reply Full Topic
noomg

 

Joined: 08-02-2018
Location: Long Beach, California USA
Posts: 452
Status: 
Offline
 Well I've gotten the old seats and what was left of the carpeting out along with the requisite clean up, rust mitigation, resealing and painting.

Next is figuring out where everything in the new carpet kit goes, typical of any Brit trim kit there are no directions. Over the years I've replaced; tops, tonneau covers, carpeting, seat covers with zero directions, I guess the assumption is you know what you're doing.

Some of the carpet pieces are obvious others not so much, it's sort of a process of elimination, but the pieces are starting to fall into place(pun intended).

A word about the jute backing. If your ordering from McGregor it's good stuff and pretty close to the original but make sure you measure up for what you need. I ordered 3 yards and I probably needed twice that since I'm doing the floor boards as well as the trans tunnel and rear wheel arches.