 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 10-12-2005 |
| Location: | Lusby, Maryland USA |
| Posts: | 7 |
| Status: |
Offline
|
I am building a kit car (not a fit car, sorry) that normally would use an MGB engine and trans. I have a line on a 907 and 4 speed from a JH that I would like to use instead. I found a website from a guy that put a 907 in an MGB, and he wrote that the 907/4 speed requires that the driveshaft be offset to one side. Is this correct? Is the differential in a Jensen Healy not in the center of the rear axle? If so, can anyone tell me how much it is offset?
Thanks,
Thurman
Last edited on 10-12-2005 06:58 pm by thurman