View single post by noomg
 Posted: 01-31-2019 05:36 pm
PM Quote Reply Full Topic
noomg

 

Joined: 08-02-2018
Location: Long Beach, California USA
Posts: 452
Status: 
Offline
 I had a pair of old sun visors which had turned to bags of sand which they typically do. I was going to send them to Delta for rebuild but instead I stripped them down to the frames and made new visors out of a 3/16" sheet of dark tinted plexiglass. I like this solution because it not only shields the sun but you can still see through them.

If you have no original visors to start with it would be relatively simple to fashion a set of brackets out of round 1/4" steel stock and some thin sheet metal which can be bent around the brackets to make a hinge which the plexiglass visors can be attached to.