 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Kingman, Arizona USA |
| Posts: | 532 |
| Status: |
Offline
|
Attachment: Ball joint lower 2.jpg (Downloaded 233 times)
| View single post by Mark Rosenbaum | |||||||||||||
| Posted: 10-08-2005 11:32 pm |
|
||||||||||||
Mark Rosenbaum
|
As suggested by the attached photo, the ball joints do just press in, but they fit very tightly. If you have a 2- or 3-jaw puller of a suitable size, you can use it, combined with a socket to fit around the threaded shaft and apply force to the body of the joint. Or, as you mentioned, you could pay perhaps $5 or $10 an arm at a shop. Attachment: Ball joint lower 2.jpg (Downloaded 233 times)
|
||||||||||||
|
| |||||||||||||