View single post by Ralph H
 Posted: 04-05-2018 08:47 pm
PM Quote Reply Full Topic
Ralph H



Joined: 03-13-2018
Location: 1974 Jensen Healey # 15681, New Brunswick Canada
Posts: 45
Status: 
Offline
 Hi All I took the front bumper off to refinish and found a couple bent pieces that I then straightened out. The DPO had installed the bumper using one bolt per side onto the frame and one bolt per side onto the bumper itself. In doing this the DPO bent the brackets all to heck so the alignment holes are messed up. A bit flimsy to be sure trying to correct that now.

So my question: do the bumper ends wrap around the outside of the side fenders or do they tuck inside the leading edge of the fenders. neither option works for me at this point due to massive alignment issues. It would appear that the front left corner of the car was used to stop the car on one occasion so the body work is rather twisted.