 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-12-2011 |
| Location: | |
| Posts: | 47 |
| Status: |
Offline
|
| View single post by Steve Duncan | |||||||||||||
| Posted: 04-01-2018 12:02 am |
|
||||||||||||
Steve Duncan
|
Replacing the rear suspension bushings. Lower arms were easy. Hole saw to cut through old rubber, then sawsall to cut through metal cylinder that was left. Popped out, no problem. Next up was upper rear suspension arms. Can't get the pressed-in old bushings out of the differential. Made a press out of all-thead and some pieces of pipe but can't get 'em to budge. Anybody been here before? Could really use some advice.
|
||||||||||||
|
| |||||||||||||